Please can some one tell what that hole on the right hand side of the heater unit does?
It is blowing air out it and I would like to know if it should be do that or do I NEED to block the hole.
Also I have finished my wheels and take a look at the photo.
heater
Moderator: Gavin McArdle
-
trippdl
- Posts: 174
- Joined: Mon Jul 23, 2007 2:28 pm
- Mem No.: 2163
- Location: Darlington
- Contact:
Re: heater
Hello Blue -
Looking at the heater photo, that hole is where the inlet pipe is on my Genie heater; I suspect that a previous owner has replaced the heater matrix, and either has not plugged the old hole, or the plug has been removed. I think you should block it off with a plastic plug.
The wheels look nice, good job!
Dave
Looking at the heater photo, that hole is where the inlet pipe is on my Genie heater; I suspect that a previous owner has replaced the heater matrix, and either has not plugged the old hole, or the plug has been removed. I think you should block it off with a plastic plug.
The wheels look nice, good job!
Dave
-
blue1
- Posts: 80
- Joined: Mon Dec 01, 2008 11:05 pm
- Mem No.: 2421
- Location: London
Re: heater
Thank you for the advice Dave.
I would like to greybags and craig for the wheel refurb idea as this has save me a load of cash. It is remarkable what you can do with sandpaper and spraypaint.
I would like to greybags and craig for the wheel refurb idea as this has save me a load of cash. It is remarkable what you can do with sandpaper and spraypaint.
Who is online
Users browsing this forum: No registered users and 1 guest